Avaya 1140E Manuale Utente Pagina 107
- Pagina / 158
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Introduction 107
Table 20
VLAN Filter
VLAN Filter Setting
Result
Enabled (box is checked) Traffic is forwarded to the IP Phone 1140E port,
based on a review of the MAC address of the
packet as well as the 802.1q tag value. Traffic
is forwarded through the IP Phone 1140E port,
(to the network stack of the telephone), only if
the packet matches the MAC address of the IP
Phone 1140E and contains the Voice VLAN tag.
If the Automatic VLAN Discovery feature is used,
the filter is adjusted dynamically as the IP Phone
1140E validates the VLAN suggested by DHCP.
Disabled The VLAN filter is disabled by default. If the
VLAN filter is disabled, traffic is forwarded to the
IP Phone 1140E port based only on a review of
the MAC address of the packet. The IP Phone
1140E accepts traffic addressed to the MAC
address of the IP Phone 1140E as well as any
broadcast or multicast packets from any VLAN.
Ctrl Priority bits
802.1Q priority bits for the control or signaling stream. There is not a control
priority bit prompt if 802.1Q is not enabled.
Media Priority bits
802.1Q priority bits for the media (audio) stream There is not a media
priority bit prompt if 802.1Q is not enabled.
Disable PC Port
With a disabled PC Port, the IP Phone 1140E with SIP Firmware does not
receive or send packets to or from the PC port. No device can use the
PC port to connect to the network.
Data VLAN
Configure the Data VLAN (the VLAN applicable to the PC port). The
behavior of the PC port is summarized in the following table.
Table 21
PC Port (incoming traffic from PC)
Data VLAN Result
No VLAN All traffic received on the PC port is forwarded
based on the MAC address. The packets are not
modified in any way.
SIP Fir mware Release 2.0 for IP Phone 1140E Administration
NN43113-300 03.09 Standard
15 September 2008
Copyright © 2008, Nortel Networks
.
- Phone 1140E Administration 1
- Contents 3
- 6 Contents 6
- New in this release 7
- RFC 3581 8
- RTP port configuration 9
- Voice Quality Monitoring 9
- Shared Call Appearance 10
- Transfer to Voice Mail 10
- Other changes 10
- Other changes 11 11
- 12 New in this release 12
- How to Get Help 13
- 14 How to Get Help 14
- Introduction to this guide 15
- Related publications 17
- 18 Introduction to this guide 18
- Related documentation 20
- Installation overview 21
- 22 Overview 22
- Figure 2 22
- Introduction 23 23
- Figure 3 23
- Supported SIP proxy ser vers 24
- Before installation 25
- Preinstallation 27 27
- 28 Before installation 28
- How provisioning works 29
- Procedure 3 30
- Figure 4 31
- Sample provisioning file 31
- Device configuration commands 40
- Feature configuration commands 42
- QoS and ToS commands 53
- Tone configuration commands 54
- NAT configuration commands 55
- VQMon configuration commands 57
- System commands 59
- Set configuration commands 60
- Figure 6 62
- Sample dialing plan 62
- Dialing function description 63
- Dialing plan 63
- Figure 9 64
- Figure 10 66
- DRegex rules 66
- Downloadable WAV files 67
- Configure the DHCP server 69
- Full DHCP mode 70
- SIP IP Phone class identifier 71
- DHCP VLAN Auto Discovery 73
- 74 Configure the DHCP server 74
- Procedure 4 75
- Installing the IP Phone 1140E 75
- Figure 11 77
- IP Phone 1140E connections 77
- 1140E firmware 79
- Procedure 6 80
- Procedure 7 81
- 3. [FW] Finished 89
- Server set-up 92
- How VQMon works 92
- End of call report 93
- Session interval report 93
- Alert interval report 93
- 94 Voice Quality Monitoring 94
- Introduction 95
- Authorization 98
- Device ID 98
- Password 98
- Introduction 99 99
- NN43113-300 03.09 Standard 100
- 15 September 2008 100
- Voice VLAN 105
- Ntwk Port Speed 105
- Ntwk Port Duplex 105
- Disable Voice 802.1Q 105
- VLAN Filter 106
- Ctrl Priority bits 107
- Media Priority bits 107
- Disable PC Port 107
- Data VLAN 107
- Data Priority bits 108
- PC-Port Untag all 108
- Cached IP 108
- Port Speed and Duplex 109
- ATTENTION 109
- Ignore GARP 109
- Provisioning 109
- PVQMon IP 109
- NAT Traversal 110
- Configure the device settings 111
- (Single Call Arrangement) 123
- Privacy access codes 124
- Overview 125
- Location information 125
- Dialing plan configuration 126
- Characteristics of E911 calls 126
- IP Phone 1140E restrictions 127
- NAT firewall traversal 129
- 130 NAT firewall traversal 130
- Three-port switch and VLAN 131
- Phone 1140E 135
- SIP responses 136
- Default error handling 141
- SIP header fields 141
- SDP and Call Hold 145
- Transport layer protocols 145
- SIP security authentication 145
- SIP DTMF Digit transport 146
- Supported subscriptions 146
- Supported instant messaging 146
- Nortel unencrypted Yes 147
- Nortel encrypted Yes 147
- Procedure 14 149
- Reloading UNIStim Firmware 149
- IP Phone 1140E diagnostics 150
- Symbols/Numerics 153
- 154 Index 154
- Index 155 155
- VQMon set-up 91 156
Prodotti e manuali riguardandi Telefoni VoIP Avaya 1140E
Telefoni VoIP Avaya 1100 and 1200 Manuale Utente
(12 pagine)
(12 pagine)
Telefoni VoIP Avaya 1040 Guida di Installazione
(25 pagine)
(25 pagine)
Telefoni VoIP Avaya Communication Server 1000 IP Audio Conference Phone 2033 Guida Utente
(94 pagine)
(94 pagine)
Telefoni VoIP Avaya 1120E-1140E Manuale Utente
(29 pagine)
(29 pagine)
Telefoni VoIP Avaya I2050 Guida di Installazione
(56 pagine)
(56 pagine)
Telefoni VoIP Avaya 1120E Manuale Utente
(2 pagine)
(2 pagine)
Telefoni VoIP Avaya 1140E Guida Utente
(50 pagine)
(50 pagine)
Telefoni VoIP Avaya IP Phone 1100 Guida Utente
(30 pagine)
(30 pagine)
Telefoni VoIP Avaya IP Phones Manuale Utente
(632 pagine)
(632 pagine)
Telefoni VoIP Avaya H.323 Manuale Utente
(8 pagine)
(8 pagine)
© 2020, manymanuals.it. Tutti i diritti riservati | 0.052 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale