Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuale Utente Scaricare il pdf (Pagina 90)

90 Chapter 2 General CLI commands

212160-A

default speed command

The default speed command sets the speed of the port to the factory default

speed. The syntax for the

default speed command is:

default speed [port <portnum|all>]

The default speed command is in the config-if command mode.

Table 38 describes the parameters and variables for the

default speed

command.

duplex command

The duplex command specifies the duplex operation for a port. The syntax for

the

duplex command is:

duplex [port <portnum|all>] {full|half|auto}

The duplex command is in the config-if command mode.

Note: When you set the port speed for autonegotiation, ensure that the

other side of the link is also set for autonegotiation.

Table 39 default speed command parameters and variables

Parameters and

variables

Description

port <portnum|all> Specifies the port number to set the speed to factory default. Enter

the port number you want to set, or all to set all ports

simultaneously.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 199 200

Nessun commento

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuale Utente Pagina 90