Avaya Configuring Ethernet, FDDI, and Token Ring Services Manuale Utente Scaricare il pdf (Pagina 13)

117344-A Rev. A

xiii

About This Guide

If you are responsible for conﬁguring Ethernet, FDDI, and token ring services on

a Bay Networks® router, you need to read this guide.

You can now use the Bay Command Console (BCC™) to conﬁgure these services

on a router. In this guide, you will ﬁnd instructions for using both the BCC and

Site Manager. Some parameters you cannot yet conﬁgure with the BCC; in these

cases, you must use Site Manager.

Before You Begin

Before using this guide with a new router, you must complete the following

procedures:

• Install the router (refer to the installation manual that came with your router).

• Connect the router to the network and create a pilot conﬁguration ﬁle (refer to

Quick-Starting Routers

Conﬁguring BayStack Remote Access

, or

Connecting

ASN Routers to a Network)

If you want to Go to

Gain access to line services Chapter 1

Learn about and customize Ethernet line services Chapter 2

Learn about and customize FDDI line services Chapter 3

Learn about and customize token ring line services Chapter 4

Obtain reference information about all line service parameters Appendix A

Obtain a listing of all line service parameters and their defaults Appendix B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 93 94

Nessun commento

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manuale Utente Pagina 13