Avaya Configuring IP Services Manuale Utente Pagina 66

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 585
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 65
Configuring IP Services
3-12 117356-A Rev. A
Starting EGP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network.For information and
instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
When you have successfully configured the circuit, the Select Protocols window
opens. Proceed as follows:
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select the
following protocols:
IP
EGP
Then click on OK.
The IP Configuration window opens.
2. Set the following parameters:
IP Address
Subnet Mask
Transmit Bcast Addr
UnNumbered Assoc Address
Click on Help or see the parameter
descriptions beginning on page A-21.
3. Click on OK. The EGP Configuration window opens.
4. Set the following parameters:
Local Autonomous System ID
(decimal)
Remote Peer IP Address
Gateway Mode
Click on Help or see the parameter
descriptions beginning on page A-17.
5. Click on OK. Site Manager enables EGP service, and
returns you to the Configuration Manager
window.
Vedere la pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 584 585

Commenti su questo manuale

Nessun commento