Avaya Quad Serial PMC Module Supplement Manuale Utente Scaricare il pdf (Pagina 18)

Quad Serial PMC Module Supplement

1-2 311905-B Rev 00

Verifying Passport 5430 Requirements

Table 1-1 shows the programmable read-only memory (PROM) boot and

diagnostic code required to use the quad serial.

The .exe files are found in the flash card.

Installing the Quad Serial PMC Module

To install a PMC module on the expansion card:

1. Attach an antistatic wrist strap, one end of the strap to your wrist and the

other end to the router chassis.

2. If the expansion card slot contains a filler panel, push it out from behind

the card bezel (Figure 1-2).

Table 1-1. Diagnostic and Boot Code for the Quad Serial PMC Module

Code Type Version Directory File Name

Boot 15.4.2.0 fbr_proms pp5430boot.exe

Diagnostic 1.16 diag.a pmc_0060.a

qscop_ram-ere 1.00

scop_rom.exe 1.00

pp5430_ram.exe ver 1.5

Note: The version numbers of the boot and diagnostic code for your Passport

5430 must match the version numbers shown in Table 1-1. If the code versions

of your switch are earlier than these, you must upgrade the PROM code.

Failure to do so may cause the Passport 5430 to not operate correctly. For

information about verifying, and upgrading PROM code, see the BayRS

Upgrading Routers guide.

Caution: Electrostatic discharge can damage hardware. You must wear the

antistatic wrist strap whenever you handle printed circuit boards. The strap

directs static electricity from your body to the router chassis, preventing

discharge to sensitive electronic components. You receive an antistatic wrist

strap with the system processor module. See the instructions included with the

wrist strap.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Nessun commento

Avaya Quad Serial PMC Module Supplement Manuale Utente Pagina 18