Avaya Configuring Data Encryption Services Manuale Utente Scaricare il pdf (Pagina 43)

Enabling Encryption

117386-A Rev. A 3-15

The Encrypt Enable parameter defaults to Disable. Both the PPP Encrypt

Enable parameter and the WEP Enable parameter must be set to Enable for

WEP to function.

6. Set a Change Time for the MEK.

The MEK Change parameter sets the amount of time, in minutes, between

changes in the MEK. The value for this attribute must be the same on both

sides of a link.

7. Click on Apply to save your changes.

8. Click on Done to exit the window.

9. Conﬁgure the WEP parameters.

Refer to “

Conﬁguring WEP Parameters,” later in this chapter.

Starting Encryption for Frame Relay

To conﬁgure encryption for Frame Relay:

1. Insert the ﬂoppy disk or other removable media that contains your NPK

and LTSS ﬁles.

Site Manager: Encrypt Enable parameter: page A-2

Site Manager: MEK Change parameter: page A-3

Note: Take the following precaution to make sure that your NPK and LTSS

source ﬁles are the ones you generated: When you enter values for the NPK,

the LTSS Value, and the LTSS Name parameters following the directions in the

steps below, make sure that the path that appears in the top bar of the

Conﬁguration Manager window, the WEP NPK window, and the WEP LTSS

window is the path that you set for your NPK and LTSS ﬁles.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 61 62

Nessun commento

Avaya Configuring Data Encryption Services Manuale Utente Pagina 43