Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manuale Utente Scaricare il pdf (Pagina 225)

Site Manager Parameters

308628-14.00 Rev 00

A-49

Parameter: Maximum Policy Rules

Path: Configuration Manager > Protocols > IP > Global

Default: 32

Options: Any integer

Function: Specifies the maximum number of policy rules that can be configured per

policy type (accept or announce) per protocol.

Instructions: To configure more than 32 accept or announce policy rules for a protocol, you

must set this parameter to a larger value. IP will round the value up to the next

multiple of 32.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.15

Parameter: Route Filter Support

Path: Configuration Manager > Protocols > IP > Global

Default: Enable

Options: Enable

Disable

Function: Specifies whether or not IP supports route filters.

Instructions: If you do not require support for route filters, select Disable. Otherwise, use the

default.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.16

Parameter: Multiple Nexthop Calculation Method

Path: Configuration Manager > Protocols > IP > Global

Default: Disable

Options: Enable

Disable

Function: Enables and disables equal-cost multipath support for RIP and OSPF and

specifies the method that IP uses to choose the next hop when more than one is

available. Three methods are available: round-robin selection, selection based

on the source addresses (IP forwards all packets with the same source address to

the same next hop), and selection based on the source and destination address

(IP forwards all packets with the same source and destination address to the

same next hop).

Instructions: Configure RIP and OSPF to support equal-cost routes to the same destination.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.18

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 307 308

Nessun commento

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manuale Utente Pagina 225