Avaya BCM 4.0 Networking Guida di Configurazione Scaricare il pdf (Pagina 119)

100

101

119

BCM 4.0 Networking Configuration Guide

Chapter 7

Managing modules

When you need to find out information about a module, you can determine the status of any of the

settings under the media bay module headings. To correct a problem, or change a module setting,

you may need to enable or disable a bus/module or select ports on the module. This section

provides the procedures that describe:

• Disabling or enabling a bus or module

• Disabling or enabling a port channel setting

Disabling or enabling a bus or module

The following procedure describes the process for enabling or disabling a bus. This means that if

there is more than one module assigned to the DS30 bus, all modules will be disabled.

To enable or disable a bus

1 Click Configuration > Resources > Telephony Resources > Modules panel, and then click

the module you wish to enable/disable.

2 Click either the Enable or Disable button.

The system prompts you to confirm your request.

3 Click OK.

Disabling or enabling a port channel setting

If you need to isolate a problem or block access from the module, you may need to turn off

individual port channels, rather than the entire module.

To turn a port channel on or off

1 On the Configuration > Resources > Telephony Resources > Modules panel, click the

module supporting the port you want to enable/disable.

2 Select the port you want to enable/disable in the Set Port Details tab.

3 Click either the Enable or Disable button.

The State field indicates the mode of operation for the port, as shown in Figure 30. If the port

is enabled, this field shows unequipped unless a device is physically connected.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 757 758

Commenti su questo manuale

Nessun commento

Avaya BCM 4.0 Networking Guida di Configurazione Pagina 119

Commenti su questo manuale

Prodotti e manuali riguardandi Networking Avaya BCM 4.0 Networking