Avaya BCM 4.0 Networking Guida di Configurazione Scaricare il pdf (Pagina 251)

100

101

Chapter 23 Configuring CLID on your system 251

BCM 4.0 Networking Configuration Guide

•The OLI number. Refer to “Line Access tab” in the BCM 4.0 Device Configuration

Guide (N0060600).

•The Auto Called ID must be selected. Refer to “Capabilities and Preferences -

Capabilities tab” in the BCM 4.0 Device Configuration Guide (N0060600).

Internal name and extension display

If you want to be able to see the CLID of internal telephones you call, ensure that Auto caller ID is

enabled; select Configuration > Telephony > System DNs > Capabilities and Preferences.

Refer to “Capabilities and Preferences main tab” in the BCM 4.0 Device Configuration

Guide (N0060600).

Programming name display (outgoing)

You can program name display for individual telephones.

On the DN record, you can change the Name field from the DN to a more logical label (Telephony

> System DNs > System DNs table > any tab). Note that only eight characters appear. Refer to

“Main panel tabs: common fields” in the BCM 4.0 Device Configuration Guide (N0060600).

Programming outgoing number display (OLI)

You can determine what number displays at the other end of an outgoing call, if the outgoing line

allows name display and the receiving telephone has number display active.

The Outgoing Line Identification (OLI) can be set for each telephone for both private and public

network calls.

The Private OLI is used for CLID over private networks. It is usually set to the DN number as a

default, although this does not always occur if there have been DN length changes. (Select

Configuration > Telephony > Sets > Active Sets > Line Access table). Refer to “Line Access

tab” in the BCM 4.0 Device Configuration Guide (N0060600). If the system is running with a

UDP dialing plan, you might want to add the LOC to the DN. Refer to “Outgoing private calls

routing” on page 328.

The Public OLI is used for CLID over public networks and for tandemed calls over private

networks that terminate on the public network. The number of digits for this field is determined by

your local service provider. (Select Configuration > Telephony > Sets > Active Sets > Line

Access table). Refer to “Line Access tab” in the BCM 4.0 Device Configuration

Guide (N0060600).

Note: OLI is not supported on analog trunks.

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 757 758

Commenti su questo manuale

Nessun commento

Avaya BCM 4.0 Networking Guida di Configurazione Pagina 251

Commenti su questo manuale

Prodotti e manuali riguardandi Networking Avaya BCM 4.0 Networking