Avaya BCM 4.0 Networking Guida di Configurazione Scaricare il pdf (Pagina 570)

100

101

570 Chapter 63 Configuring Net Link Manager

N0060606N0060606

Figure 180 Permanent WAN connection details panel

Table 134 Permanent WAN connection settings (Sheet 1 of 2)

Attribute Value Description

Net Link Manager

Enable net link

Manager

<check box> Enable or disable Net Link Manager.

Default: Enabled

Primary interface <drop-down list> Select whether the primary interface is a Permanent or Dialup

connection.

Next hop on primary

interface

<IP address> Enter the IP address (in dot format) of the next hop router.

This address is used by Net Link Manager to add a default

route in BCM. If this address ever becomes unreachable, Net

Link Manager dials the backup link and changes the default

route.

This address also identifies the default IP gateway associated

with a default route.

This is the IP address of the remote router connected via the

primary WAN connection.

Backup interface <drop-down list> Select which interface to use for WAN backup.

You must configure a backup interface before you can select it.

For information about how to create an ISDN backup interface,

refer to “Creating an ISDN dial out interface” on page 550.

Up poll interval (s) <0- 3600000> Set the polling interval on the Primary WAN Link.

The Up poll interval is the interval between successive pings

when the next hop on the primary link is available.

Default: 5 seconds

Down poll interval (s) <0- 3600000> Set the polling interval on the Primary WAN Link, in seconds,

when the primary WAN link is down, and the backup (dial-up)

WAN link is operational.

A short interval provides faster detection of the primary link

availability.

Default: 5 seconds

1 2 ... 565 566 567 568 569 570 571 572 573 574 575 ... 757 758

Commenti su questo manuale

Nessun commento

Avaya BCM 4.0 Networking Guida di Configurazione Pagina 570

Commenti su questo manuale

Prodotti e manuali riguardandi Networking Avaya BCM 4.0 Networking