Avaya BCM 2.0 Programming Guida Utente Scaricare il pdf (Pagina 165)

Configuring Enterprise Edge Services 165

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

Programming Network Name Display

The Business name and the Set name make up the information that is used for the

outgoing Calling name or connected name.

Calling/connected name is only sent once the Business name is programmed. To

program the Business name, see General Settings on page 147. It is recommended

that you use a blank space for the last character of the Business name to act as a

separator between the Business name and Set name.

To program the Set Name:

1. Under Services, Telephony Services, Terminals & sets, General settings

select the set number of the telephone

2. In the Business name box, type the Business name (7 characters).

3. Other areas that must also be programmed include:

• The OLI number, see OLI number on page 95.

• Under Telco Features, the Call ID must be set to Yes, see Auto called ID on

page 107

• Under Lines, type the set number where you want the CLID to appear, see

CLID set on page 113.

Outgoing name and number blocking (ONN)

When you activate, ƒ°⁄· blocks the outgoing name and number

(ONN) on a per call basis. When you use this feature, the system flags the call to

the CO so that the name and number does not present to the person you call.

Enterprise Edge alerts the CO by two methods and each depends on the type of

trunk involved in placing the outgoing call. Analog trunks use a dialing digit

sequence called a Vertical Service Code (VSC). The VSC differs from region to

region and must be programmed. Analog trunks with both tone and pulse dialing

trunks can have separate VSCs. PRI trunks have only one VSC.

To configure ONN:

1. Under Services, Telephony Services, Telco features, two options are

available.

2. For analog trunks under Voice message center numbers, ONN blocking,

Analog VCS, Tone:None. You can choose F78, (0-9), *, #.

3. Type a new tone dialing Name and Number blocking digit sequence.

4. For non-analog trunks under Voice message center numbers, ONN

blocking, Pulse:None. You can choose F78, (0-9), *, #.

5. Type a new pulse dialing Name and Number blocking digit sequence.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 445 446

Nessun commento

Avaya BCM 2.0 Programming Guida Utente Pagina 165