Avaya BCM 2.0 Programming Guida Utente Scaricare il pdf (Pagina 79)

Configuring Enterprise Edge Resources 79

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

The loss plan follows the Draft TIA-464-C loss plan. The ISDN loss plan uses a

send loudness rating (SLR) of 8 dB and a receive loudness rating (RLR) of 2 dB.

The PSTN loss plan uses an SLR of 11 dB and an RLR of -3 dB. Choosing the

wrong setting may affect voice quality, either too loud or too soft.

Internal CSU

Internal CSU lets you turn the internal T1 channel service unit on or off. The

channel service unit gathers performance statistics for your T1 lines or PRI with

public interface. Contact your service provider for the proper settings.

Note: You must disable the EE-DTM before you can change this setting. See

Media Bay Module status on page 279 for details.

You can view the performance statistics for your T1 lines in Maintenance under the

CSU stats heading. If you set the internal CSU off, there must be an external CSU

connected to your T1 lines.

E1 Parameters (Europe)

Enterprise Edge does not provide E1 parameters. If your Enterprise Edge is

connecting to a network using E1 trunks, make sure CRC4 checking is enabled at

the other end.

Configuring a data module

Module08 is reserved for adata module.The data moduleprovides connectivityfor

a soft router through Enterprise Edge from facilities such as T1 and BRI. The

remote soft router server only needs to be powered up and running for the feature

tobe available. Enterprise Edge automatically configures the Module type as a Data

Module, sets the Data module type to Baystack, and sets the IP address. Baystack

is currently the only soft router supported on Enterprise Edge.

Viewing the data module settings

Use the following procedure to view the current settings for the data module.

1. Under Resources, Media Bay Modules, choose Bus 08.

Note: Before you can configure the data module for fixed access, you must first

configure an EE-DTM module as T1(see Module on page 72) and you must

set the trunk type to Fixed data channel (see Trunk/line data on page 111).

Programming the BayStack settings

When you select the BayStack data module, the following configuration settings

appear:

• IP address

• Switched access

• Line assignment

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 445 446

Nessun commento

Avaya BCM 2.0 Programming Guida Utente Pagina 79